Derungs D med IRIS LED 10 Montage- Und Gebrauchsanweisung Seite 29

Insert ceiling tube 1 into ceiling bracket 2 and

drill with Ø = 9mm 3. Use the existing hole in
the ceiling bearing as a guide.

Make 4 opposited
(Ø13mm), note the position of the Ø60mm drill
hole for electrical connections

Check clearances

Drill the bore holes, then blow them out using
bellows
WARNING
The light will fall
incorrectly

The threaded pins must be screwed in fully and
correctly.
drill hole markings
if fastening is done
Perform this assembly step on a flat

surface:

Loosen 4x countersunk screw M3 and remove
cover 1
Lay connecting piece 2 down flat


Pull both cables (of the arms) through the
connecting piece 2 , the cover 1 and the ceiling
conduit 3
Mount cover 1 again

Insert slide pad 4 into the groove at the top of

the connecting piece
Push ceiling conduit 3 (with boring aligned

upward) and connecting piece 2 together
Secure slide pad 4 by screwing in the threaded

pin 5 (up to the stop)
Release threaded pin 5 by a ¼ turn maximum

and check function

Also check:
Threaded pin must now be flush
ENG
29