Measuring; Guarantee; Declaration Of Conformity - TESA INOTEST Gebrauchsanleitung

INOTEST

4 MEASURING

5 GUARANTEE

6 DECLARATION OF CONFORMITY

8
– Draw back the sensing cylinder by means of the
lever, place the INOTEST on the workpiece, then
release the lever gently.
– Keeping the fixed anvil in contact with the work-
piece, swing the mobile anvil in a small arc until
the dial gauge indicates the correct gauging
point.
We guarantee the product against any fault of de-
sign, manufacture or material for a period of 12
months from the date of purchase. Any repair work
carried out under the guarantee conditions is free of
charge. Our responsibility is limited to the repair of
the instrument or, if we consider it necessary, to its
free replacement.
Thank you very much for your confidence in pur-
chasing this product. We hereby certify that it was
inspected in our works. We declare under our sole
responsability that the quality of this product is in
conformity with standards, technical data and Euro-
pean directives as specified in our sales literature
– Note the deviation from the nominal size.
When measuring large dimensions, it is particularly
important to keep the fixed anvil in firm contact with
the workpiece.
The following are not covered by our guarantee:
batteries and damage due to incorrect handling, fai-
lure to observe the instruction manual, or attempts
by any unqualified party to repair the product; any
consequences whatever which may be connected
either directly or indirectly with the product sup-
plied or its use.
(Extract from our General Terms of Delivery
from December 1st, 1981)
(instruction manuals, leaflets, catalogues). In addi-
tion, we certify that the measuring equipment used
to check this product refers to national standards.
The traceability is ensured by our Quality Assu-
rance.
Quality Assurance