Instrument Fitted With Supplementary Base Rails - Tesa Inotest Gebrauchsanleitung

– Place the INOTEST on the master gauge (Fig. 8).
– Slacken the screws 20 and slide the extension
– Ensure that the support plate edges 2, 10 are
– Approximately set the dial gauge by slackening
3.2 – Slacken the adjustable fixed anvil 19. Place the
Instrument fitted with
supplementary base
rails
20
telescopically to bring the measuring anvils 4
into contact with the master gauge.
mutually parallel (markings upwards), and lock
with screws 20.
the screw 12 by a halfturn and withdrawing or
instrument on the master gauge and position the
fixed anvil to bring the mobile anvil and the fixed
anvil into contact with the master gauge. Lock
the fixed anvil in this position.
Fig. 8.
19
inserting the dial gauge until the pointer is ap-
proximately central and can still travel an ade-
quate distance when measuring. Lock with the
screw 12.
– Swing the measuring head gently back and forth
until the correct gauging point is found, then set
the dial gauge to zero by rotating the bezel 21.
– Check for correct repetition.
– Continue the calibration operation as described
in para. 3.1.
Fig. 9.
INOTEST
21 5
7