Assemnling; Internal Measurement; External Measurement; Accessories - Tesa Inotest Gebrauchsanleitung

2 ASSEMBLING
2.1 – Loosen the fixing screw 12 and insert the dial

Internal measurement

– Fit the spring housing 7 up to the stop as shown,
Side A
2.2 – Loosen the fixing screw 12, insert the dial gauge

External measurement

2.3 Measuring is more convenient if the rectangular

Accessories

support plates 16, fitted with supporting bolts 15,
are used to suspend the instrument in position.
(Fig. 5).
15
gauge 5 up to the stop. Then tighten the fixging
screw 12 (Fig. 4, side B).
and tighten the other fixing screw 12.
7 12
13
5 up to the stop and retighten the screw 12 (Fig.
4, side A).
16 15
– Select the extensions corresponding to the
length to be measured, fit to the measuring
head, and tighten the fixing screws 13.
– Introduce the measuring anvils 4 into the clamps,
and lock with the screw 14.
12
13
Fig. 4.
– Fit the spring housing 7 up to the stop as shown
and tighten the other fixing screw 12.
– Fit the extensions and measuring anvils as des-
cribed in para. 2.1.
16
Fig. 5.
INOTEST
5
14 4
16
15
Coté B
5