EdilKamin MAXIMA series Installations-, Betriebs- Und Wartungsanleitung Seite 96

POSSIBLE TROUBLESHOOTING
LIST OF MESSAGES IN THE MESSAGE WINDOW
Below is the list of messages displayed on the synoptic panel in the Message Window of the Home tab
BOILER OFF
BOILER RELOADING
BOILER IGNITION
BOILER HEATING
BOILER WORKING
BOILER SHUTTING DOWN
BOILER BLOCKED
Perform TAC Maintenance
Perform User Maintenance
Check clock battery
Pellet hopper in reserve
Check extraction
Burner blocked
External thermostat active
Start cleaning burner grilles
Cleaning of burner grilles in progress
Cleaning of burner grilles performed
Micro-cleaning of grilles in progress
Standard cleaning in progress
PLUS cleaning in progress
Smoke evacuation test circuit
PRIMARY AIR RESET
BOILER IN ENERGY-SAVING MODE
BRUSH-CLEANING BLOCKED
RETURN WATER SENSOR FAULT
LAMBDA SENSOR FAILURE
NO CONSOLE/BOILER BOARD CONNEC-
TION
LIST OF TEMPORARY MESSAGES
MESSAGE
The data was saved
Error saving the data
Communication Error!!!
Start cleaning the display
ATTENTION: Error in line ...
Read error
Write error
MicroSD not present!
The boiler is not running and is waiting for commands from the user
Pellets are being reloaded in the screw
Displayed during ignition of the boiler, this phase is accompanied by a countdown of the time
remaining until the end of the ignition phase
Displayed immediately after ignition, as the boiler is reaching working temperature, this phase
is accompanied by a countdown of the time remaining until the end of the heating phase
Displayed after the heating phase, it indicates that the boiler is working properly
Displayed during the normal shutdown of the boiler, this phase is accompanied by a countdown
of the time remaining until complete shutdown
Displayed during shutdown due to an alarm, this phase is accompanied by a countdown of the
time remaining until complete shutdown
Indicates the need for maintenance by the technical assistance centre
Indicates the need to perform routine maintenance
The battery mounted on the boiler board may be faulty or malfunctioning
This indicates that the nominal amount of pellets in the hopper is low, you should add pellets.
The Leonardo system test has detected abnormal suction
Burner did not return to its seat after an automatic cleaning
Indicates that the thermostat connected to the boiler is active (optional)
Indicates the start of the burner cleaning phase
Indicates that cleaning of the burner is in progress
Indicates that cleaning of the burner is completed
Indicates that micro-cleaning of the burner is in progress
Indicates that cleaning by hyperventilation of the burner is in progress
Indicates that micro-cleaning of the burner plus interruption of loading is in progress
Displayed during the ignition phase, indicates that the proper functioning of the smoke extrac-
tion circuit is being checked
The damper is being aligned
The boiler was turned off by the economy function
Indicates that automatic cleaning of the brushes is blocked
Indicates that the probe that measures the temperature of the return water is out of service
Indicates that the lambda probe that regulates combustion is out of service
Indicates that the touch-screen control interface is not communicating with the boiler board
MEANING
Displayed when you press the Save button in the various menus if the data was properly saved
Displayed if there was a problem saving data after pressing the Save button in the various
menus
The console is unable to communicate with the boiler
Displayed during the display cleaning phase
Displayed when the time slots are not programmed correctly
Displayed if the response message of the boiler to a read message was corrupted
Displayed if the response message of the boiler to a write message was corrupted
Displayed when an access attempt is made to a menu requiring a memory card to be inserted
- 96
-