Fora 6 Connect Bedienungsanleitung Seite 9

Note:
To avoid contaminating the control solution, do not directly
apply the control solution onto a strip.
4. Read and compare the result. After counting down to 0, the
test result of the control solution will appear on the display.
Compare this result with the range printed on the test strip
vial or individual foil pack and it should fall within this range.
If the test result is out of range, read the instructions again
and repeat the control solution test.
118~160
Note:
• Control solution test results are stored in the memory.
• The control solution range printed on the test strip vial or
individual foil pack is for control solution use only. It is not
the recommended range or reference values.
• Refer to the Maintenance section for important information
about your control solutions.
Out-of-range results:
If you continue to get results that fall outside the range printed
on the test strip vial, it means that the meter and strips might
not be working properly.
EN-7