Replacing The Fuse; Appendix - Futurelight SC-240 Scanner Bedienungsanleitung

Replacing the fuse

If the lamp burns out, the fine-wire fuse of the device might fuse, too. Only replace the fuse by a fuse of
same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Unscrew the fuseholder on the rearpanel with a fitting screwdriver from the housing (anti-
clockwise).
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing and fix it.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged (cable firmly connected with the device), it has to
be replaced by authorized dealers only in order to avoid hazards.
If the power supply cable of this device becomes damaged (replaceable cable), it has to be replaced by a
special power supply cable available at your dealer.
Should you have further questions, please contact your dealer.
We hope you will enjoy your SC-240. We can assure you that you will enjoy this device for years if you follow
the instructions given in this manual.
Should you have further questions, do not hesitate to contact your local dealer.
All rights reserved (including those of translations in other languages). No part of this user manual
may be reproduced or changed without written permission from the publisher.
Please note: Every information is subject to change without prior notice. 11/00 ©

Appendix

28