Start-Up; Assembly; To Screw-On The Adapter; Connection Of The Pressure Line - FLORABEST FTP 400 B2 Originalbetriebsanleitung

plug connections in an area that is safe
from flooding.
• Ensure that the mains voltage matches
the specifications on the rating plate.
• The electrical installation shall be ac-
cording to national wiring rules.
• Connect the equipment only to a sock-
et with a residual current protection
device (residual current circuit breaker)
with a rated current of not more than
30 mA; minimum fuse 6 amperes.
• Before each use, check the equipment,
cable and plug for damage. Defec-
tive cables are not to be repaired, but
rather replaced by new ones. Have
damage on your equipment repaired
by an authorised specialist.
• If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer, a customer service agent
of the same or a similarly qualified per-
son in order to prevent hazards.
• Do not pull the plug from the socket by
the cable. Protect the cable from heat,
oil and sharp edges.
• Do not carry or fix the equipment by
the cable.
• Use only extension cables that are pro-
tected from spray water and designed
for outdoor use. Always fully unroll a
cable drum before use. Check the ca-
ble for damage.
• Disconnect the mains plug from the
socket before all work on the equip-
ment, in case of leaks in the water sys-
tem, during work breaks, and when not
in use.
• The cross-section of mains connection
lines must be no smaller than rub-
ber hose lines with the designation
H07RN-F. The line must be 10 m long.
The flexible lead cross-section of the ex-
tension cord must at least 2.5 mm

Start-up

Assembly

1. Screw the angle adapter (11)
2. Position the float switch cable (7)
Connection of the pressure
line
The installation of the submersible water
pump is implemented either
- with fixed pipe or
- with flexible hose line
• If using a ½" hose, attach the
• To use a ¾", 1" or 1½" hose, cut
• To use a tap adaptor (G1") to
Measurement of maximum output
data takes place during direct,
straight pumping. The angle adapt-
er (
per (
. To increase pump output, the backflow
2
stopper (10) may be taken out of the angle

To screw-on the adapter:

and the adapter with the hose
connection (9) onto the pump
outlet (5).
Installing the float switch
in the float switch grid (8).
hose over the pump's hose con-
nection (9) and fasten it with a
hose clamp if necessary.
off the connection above and at-
tach the hose over the correct con-
nection (fixing with a hose
connect external hose connec-
tion systems, cut off the two top
connections directly above the
G1" tube thread.
11) and the backflow stop-
10) may reduce output.
GB
clamp).
45