Operational Start-Up; Ssem L; Connection Of The Pressure Line; To Erect/Suspend - FLORABEST FTP 400 D3 Originalbetriebsanleitung

G B I E
Operational
Assembly
To screw-on the adaptor:
1. Screw the angle adaptor (12)
and the hose adaptor (10) onto
the pump outlet (5).
To mount the float switch
height adjustment:
2. Loosen t e scre
switch height adjustment (7) and
push the adjustment over the
oat s itc
t at t e oat s itc ca le 8
moves upward (arrow
up) (see „Operation").
Connection of the pressure
line
The installation of the submersible water
pump is implemented either
- it ed pipe or
- it e i le ose line
• If using a ½" hose, attach the
hose over the pump's hose con-
nection (10) and fasten it with a
ose clamp if necessar .
• To use a ¾", 1" or 1½" hose,
cut off the connection above and
attach the hose over the correct
connection
clamp).
• For the use of a tap connector
with internal thread (G 1") for
connecting external hose con-
nection s stems c t t e top t ree
connections off directl over t e
G 1" threaded pipe.
• Connect a tap connector with
internal t read
to the angle adapter (
2 2
start-up
of t e oat
ide a 9 . ec
to point
in it a ose
1 directl
12).
The measurement of the maximum
performance data takes place
under optimal conditions, such as
a straight, direct exit. The angle
adaptor (
stopper (
o increase p mp o tp t t e ac o
stopper 11 ma
adaptor (12) (see
stopper . is is partic larl recom-
mended for hose connections smaller than
1 . lease ear in mind t at t e
t en o ac d rin p mpin
event of a power cut.

To erect/suspend

The pump can be erected or sus-
pended in the water.
The cord (
deliver contents ma
suspend and/or extract the pump.
The pump shaft should have the dimen-
sions 0 0 0 cm at least so t at t e
oat s itc can move freel .
i t e n lon rope 13 onto t e car-
r in andle 1 .
Ensure that the equipment is
not hung up or held by the
mains cable. There is a risk
of electric shock from dam-
aged mains cables.
Note that, over time, dirt and sand
ma collect on t e ottom of t e
shaft, which could damage the
pump.
We recommend placing the pump
on a brick or a grid.
12 and t e ac o
11) ma red ce o tp t.
e ta en o t of t e an le
replacin ac o
ater ma
or in t e
13) contained in the
e sed to