PeakTech 1070 Bedienungsanleitung Seite 3

4.8. Diodenprüfung
1. Rote Prüfleitung an den V/Ω/mA-Eingang und
schwarze Prüfleitung an
anschließen.
2. Funktions-/Bereichswahlschalter
wünschten Bereich drehen.
3. Zum Messen von Dioden rote Prüfleitung an die
Anode und schwarze Prüfleitung an die Kathode
anschließen.
4. Die Anzeige zeigt die Vorwärtsspannung der
Diode an. Andere Polung zeigt Überlauf "1".
4.9. Temperaturmessung
1. Typ-K-Temperaturfühler an die V/Ω/mA-Buchse
und COM-Buchse anschließen
2. Funktionswahlschalter in Stellung „TEMP" drehen
3. Messung vornehmen
4. Messwert in der Anzeige ablesen.
-17-
* Do not use this instrument for high-energy industrial
den COM-Eingang
* Do not place the equipment on damp or wet surfaces.
* Do not exceed the maximum permissible input ratings
auf den ge-
* The meter is designed to withstand the stated max
* Replace a defective fuse only with a fuse of the original
* Disconnect test leads or probe from the measuring
* Do not conduct voltage measurements with the test
* To avoid electric shock, disconnect power to the unit
* Do not conduct current measurements with the leads
* Check test leads and probes for faulty insulation or
* Please use only 4mm-safety test leads to ensure
installation measurement. This instrument is intended
for use in installation over voltage category II according
to IEC 664. For measuring circuit not exceeding 600V
DC / AC, 10A.
(danger of serious injury and/or destruction of the
equipment).
voltages. If it is not possible to exclude without that
impulses, transients, disturbance or for other reasons,
these voltages are exceeded a suitable presale (10:1)
must be used.
rating. Never short-circuit fuse or fuse holding.
circuit before switching modes or functions.
leads connected to the mA/A- and COM-terminal of the
equipment.
under test and discharge all capacitors before taking
any resistance measurements.
connected to the V/Ω-terminals of the equipment.
bare wires before connection to the equipment.
immaculate function.
-22-