Worx PROFESSIONAL WU530 Übersetzung Der Originalanleitung Seite 9

angles and depths of cut.
2 check the operation of the lower guard spring. if the guard and
the spring are not operating properly, they must be serviced
before use. Lower guard may operate sluggishly due to damaged
parts, gummy deposits, or a build-up of debris.
3
lower guard may be retracted manually only for special cuts such
as "plunge cuts" and "compound cuts." raise lower guard by
retracting handle and as soon as blade enters the material, the
lower guard must be released. For all other sawing, the lower guard
should operate automatically.
4 always observe that the lower guard is covering the blade before
placing saw down on bench or floor. An unprotected, coasting
blade will cause the saw to walk backwards, cutting whatever is in its
path. Be aware of the time it takes for the blade to stop after switch
is released.
Symbols
To reduce the risk of injury, user must read instruction
manual
Warning
Wear ear protection
Wear eye protection
Wear dust mask
Indoor use only
Do not expose to rain or water
Do not burn
Do not dispose of batteries. Return exhausted batteries to
your local collection or recycling point
9