Worx PROFESSIONAL WU530 Übersetzung Der Originalanleitung Seite 11

• Take care that the mounting positions of the inner flange and
outer flange are correct.
• When mounting: ensure that the cutting direction of the teeth
(direction of arrow on saw blade) and the direction-of-rotation
arrow on the blade guard match.
5
HeX Key STorage (See fig.B)
The hex key provided can be placed in the area under the machine
motor.
6
DUST/cHiP eXTracTion (See fig.f)
Fasten the vacuum adapter (14) onto the dust extraction outlet (26)
until it latches. Directly connect a suitable vacuum hose to the adapter.
The vacuum adapter must not be mounted when no external
dust extraction is connected. Otherwise there is danger of the
extraction system becoming clogged.
Clean the vacuum adapter regularly to ensure optimum dust
extraction. The vacuum cleaner must be suitable for the material to be
worked.
Before PUTTing inTo oPeraTion
1) BaTTery cHarging
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When the
battery is empty, the machine is switched off by means of a protective
circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the battery is charged for the first time and after prolonged
storage, the battery will only accept approximately 60% charge.
However, after several charge and discharge cycles the battery will
accept a 100% charge.
2) To reMoVe or inSTall BaTTery PacK (See fig.a)
Press the battery pack release button and remove the battery pack
from the tool. After recharge, slide the battery pack into tool's battery
port. A simple push and slight pressure will be sufficient.
STarTing oPeraTion
1
SWiTHcing on anD off
For starting operation the machine, actuate the lock-off button (1) first,
and then press and hold the On/off switch (2) afterwards.
To switch off the machine, release the On/off switch (2).
for safety reasons the on/off switch of the machine cannot be
locked; it must remain pressed during the entire operation.
2
elecTrical BraKe
An integrated electrical brake immediately reduces the speed of the
saw together with the saw blade after switching off the machine.
Working hints for your cordless
circular saw
Always use a blade suited to the material and material thickness to
be cut. The quality of cut will improve as the number of blade teeth
increase. Always ensure the work-piece is firmly held or clamped to
11