Worx PROFESSIONAL WU530 Übersetzung Der Originalanleitung Seite 10

Operating instructions
note: Before using the tool, read the instruction book carefully.
inTenDeD USe:
The machine is intended for lengthways and crossways cutting of
wood with straight cutting lines as well as bevel angles to 50° while
resting firmly on the work piece.
1 aDJUST THe cUTTing DePTH (See fig.c)
To achieve an optimum cut, the saw blade must not protrude the
material. For adjusting the cutting depth, loosen the cutting depth lock
knob (24) and raise the saw from the base plate, or lower it to the base
plate respectively. Adjust the required cutting depth using the cutting
depth scale (22). Tighten the cutting depth lock knob again.
2 aDJUST THe cUTTing angle (See fig.D1,D2)
Turn the base plate bevel lock (6) in anti-clockwise direction to loosen
the angle scale. Tilt the base plate away from the machine until the
required cutting angle is adjusted on the angle scale (5). Tighten the
bevel lock (6) by turning it in clockwise direction.
note: The 45°degree has a fast and positive stop. You can use this
angle exactly. If you want to use bigger cutting angle, you can push
the bevel lock along the path
3 cUTTing gUiDe (See fig.e)
The Accutrak (8) fixed in front of the base plate is used as cutting
TM
guide. Always guide it along the cutting mark made on the workpiece
for accurate cutting.
The cutting mark 0° indicates the position of the saw blade for right-
and tighten the bevel lock.
2
angled cuts.
note: It is best to carry out a trial cut.
4
cHanging THe SaW BlaDe (See fig.a)
• Before any work on the machine itself, remove the battery.
• Wear protective gloves when mounting the saw blade. Danger
of injury when touching the saw blade.
• only use saw blades that correspond with the characteristic
data given in the operating instructions.
• Do not under any circumstances use grinding discs as the
cutting tool.
For changing the cutting tool, it is best to place the machine on the
face side of the motor housing.
reMoVing
Press the spindle lock button (4) and keep it depressed.
The spindle lock button (4) may be actuated only when the saw blade
is at a standstill.
Loosen the blade bolt (17) in clockwise direction with the hex key (23).
Remove the outer flange (18). Tilt back the lower blade guard (12) and
hold it firmly with the lower guard lever (11). Remove the saw blade
(19).
MoUnTing
Clean the saw blade and all the clamping parts to be assembled.
Tilt back the lower blade guard (12) and hold it firmly with the lower
guard lever (11). Place the saw blade (19) onto the inner flange (21).
Assemble the outer flange (18) and the blade bolt (17). Use the hex
key to tighten the blade bolt (17) in anti-clockwise direction with 1/4
turn more than finger tight.
10