Cleaning And Care - Klarstein 10010176 Handbuch

Cleaning and Care

Clean the dispenser each time the beer keg is replaced. Clean the dispenser well to avoid negatively affecting
the taste of the beer. Never use abrasive scouring pads or cleaning pads to clean any part of the dispenser.
Do not use abrasive cleansers such as acetone, petrol, thinner, vinegar or similar cleansers. Prior to cleaning,
switch off the dispenser and disconnect the power plug (14). Wipe the dispenser off with a slightly damp cloth.
If necessary, use a little washing up liquid. Never pour water into the cooling chamber (18). This could damage
the dispenser.
Cleaning the drip tray and lines
Clean the drip tray (9) and drip tray cover (8) after each use. Wash it out with
warm water and if necessary, a little washing up liquid. The hose in the dispen-
sing tap should also be cleaned after each use. To do this, pull the bottom part of
the dispensing tap down to take it off. Then pull the hose out of the dispensing
tap (fig. 12). Wash the dispensing hose and the bottom part of the dispensing tap
with hot water.
Reassemble both parts after cleaning
In order to thoroughly clean the dispensing hose, use the cleaning pump
(25). To do this, secure the dispensing hose to the cleaning pump (25). Hold
the dispensing hose end of the cleaning pump (25) in a container filled with
warm water and pump water through the hose using the balloon. Squeeze
the cleaning pump (25) vigorously and repeatedly to thoroughly clean out the
dispensing hose. Please note: Use a little washing up liquid to clean the dis-
pensing hose. Then rinse the dispensing hose
with warm water to remove any washing up liquid residues. Reassemble the
dispensing hose and the bottom part of the dispensing tap.
Cleaning the dispensing unit
Always clean the dispensing unit (3) when you change beer kegs or if the dis-
penser has not been used for a long time. Clean the exterior of the dispen-
sing unit (3) with warm water and a little washing up liquid: Clean the hose
in the dispensing unit (3) with the cleaning pump (25). To do this, secure the
cleaning pump (25) to the dispensing hose (fig. 13 A) and hold the hose end
of the cleaning pump (25) in a container filled with warm water. Pump water
through the dispensing hose with the balloon. Squeeze the cleaning pump
(25) vigorously and repeatedly to thoroughly clean out the hoses of the dis-
pensing unit (3) (fig. 13 B).
Please note:
Use a little washing up liquid to clean the hose. Then rinse the lines thoroughly with warm water to remove any
washing up liquid residues. Do not clean the dispensing unit (3) and any related parts in the dishwasher. Special
disinfectant cleaners are commercially available for beer and drink dispensers in powder form. Always clean
the accessories manually with warm water. They are not suitable for dishwasher cleaning.
25