Securing A Bicycle; Attaching The Handlebar Bracket; Folding Up The Bicycle Assembly Rack; Maintenance And Care - Eufab 16421 Bedienungsanleitung

5.3 SECURING A BICYCLE

First open the frame clamp (Position 7 in the Overview) by folding up the lever of the quick closure (Position 8 in the Over-
view) and rotating anti-clockwise. Open the frame clamp just enough to enable the pipe of the bicycle frame to be inserted
between the clamping jaws. If the frame clamp is opened too wide, it is not possible to secure the bicycle firmly by closing
the quick closure lever. You may need a few attempts to work out how to set the frame clamp before you tension the bicycle
in the assembly rack.
There is a risk of injuries if the bicycle falls out of the frame clamp.
If possible, have a second person to help you tension a bicycle in the assembly rack.
If possible, the bicycle should be placed in the assembly rack in such a way that the frame clamp is positioned over the
centre of gravity of the bicycle. Now place the bicycle in the frame clamp and close the quick closure. Pay attention to ensure
that none of the brake cables or electrical lines are trapped and damaged. Check to ensure that the assembly rack is safely
positioned.
If you wish to tension the bicycle in a different position, or for example, by the
saddle pipe, it is possible to rotate the frame clamp appropriately. To do this, release
the locking mechanism from the rotating mechanism by pushing the small lever
(Position 10 in the Overview) up and then folding the locking lever (Position 11 in
the Overview) up. The teeth of the rotating mechanism are released, Figure 3.
CAUTION: Hold the bicycle securely before opening the teeth.
The bicycle may suddenly tilt into another position. There is a risk of injury.
Set the frame clamp to the desired angle and push the locking lever back down again. Make sure that the teeth mesh cleanly
again.

5.4 ATTACHING THE HANDLEBAR BRACKET

In order to be able to conveniently work on your bicycle, secure the handlebar bracket (Position 6 in the Overview) with
one end on the upper telescopic pipe. Undo the plastic screw on the handlebar bracket to adjust to the appropriate length.
Secure the other end to the handlebar or front wheel. Tighten the plastic screw up again. The front wheel is now secured
and twisting is prevented.

5.5 FOLDING UP THE BICYCLE ASSEMBLY RACK

In order to fold up the bicycle assembly rack, carry out the steps described in section 5.2 in reverse order.

6. MAINTENANCE AND CARE

Clean the bicycle assembly rack with a mild cleaning agent, with warm water and/or a soft cloth. Do not use solvents or
similar cleaning agents since these can damage the bicycle assembly rack. All adjusting elements must be kept free from
oil and grease.
Store the bicycle assembly rack in a dry location. Protect the assembly rack from direct sunlight. Store the assembly rack out
of the reach of children, and securely locked.

7. NOTES REGARDING ENVIRONMENTAL PROTECTION

Dispose of the bicycle assembly rack in accordance with the laws and conditions in your country.

8. CONTACT INFORMATION

EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal
Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
Bild 3
7