Undo the wheel rail with lights on your bicycle rack. Remove the electrical cable by cutting the cable tie. Remove the plastic caps from
the longitudinal carriers of the base frame. Slide the base frame extension elements into place there and secure with the supplied Allen
screws M6 x 15 and washers, Figure 1.
Insert base frame extension
Now insert the link screws of the wheel rail with lighting into the rear drilled holes of the base frame extension element, Figure 2. Screw
the wheel rail into place firmly. The wheel rail of the extension is placed in the middle. Screw it into place with two wing nuts.
Wheel rail
Wheel rail
with lighting
of extension
Figure 2: Position of wheel rails
5.2 Laying the electrical cable
Lay the cables along the longitudinal carrier of the base frame. The cables may not be bent, stretched or crushed, e.g. in the vicinity of the
folding mechanism. Secure the cables with the supplied cable ties. When you are finished, trim any excess material from the cable ties
using cutting pliers.
5.3 Securing the third bicycle
The third bicycle is secured with the supplied frame holder reaching from Bicycle 2 to Bicycle 3. The loose, small tensioning strap is used
to additionally secure the front wheel, Figure 2.
Additional tensioning strap
Wrap the safety strap through the bicycle frames and the U-shaped bracket and tighten.
The frame holder may cause minor pressure points on the bicycle frame and damages to the paintwork.
12
Allen screws
Figure 4: Tensioning straps for front wheel
Tensioning strap of wheel stopper
Figure 1: Insert the base frame extension element
Figure 3: Assembly completed
Wheel rail of
extension