Installtion Of The Water Drainage - Klarstein Ion Breeze Bedienungsanleitung

INSTALLTION OF THE WATER DRAINAGE

Before using DRY mode, remove the upper drain plug on the back of the unit. Attach the
drain hose to the water outlet. Place the other end of the hose in a drain or collection
vessel.
Drain outlet
If the equipment you purchased has a pump outlet (as shown below), install the water
drain as follows: Remove the pump drain plug from the rear of the unit and attach the
drain hose to the hole. Place the other end of the hose in a drain or collection vessel.
Note: Make sure that the hose is securely fastened and has no leaks. Point the hose
towards the drain and make sure that there are no kinks that could obstruct the flow of
water. Place the end of the hose in the drain and make sure that the end of the hose is
facing down so that the water can flow evenly. Make sure that the end does not point
upwards.
EN
37