Intended Use; Description Of The Device; Items Supplied - Hilti TE 30 Original Bedienungsanleitung

Careful handling and use of power tools
▶ Secure the workpiece. A workpiece clamped in a vice or secured by some other clamping device
is more secure than when held only by hand.
▶ Switch the power tool off if the accessory tool sticks and stalls. The power tool may be deflected
laterally.
▶ Wait until the power tool stops completely before you lay it down.
▶ Ensure that the accessory tools used have a mounting system that is compatible with the power
tool and that they are secured in the chuck correctly.
▶ Wear protective gloves when changing accessory tools as they get hot during use.
Work area
▶ If the work involves breaking right through, take the appropriate safety measures at the opposite
side. Parts breaking away could fall out and / or fall down and injure other persons.
3 Description
3.1 Overview of the product
Chuck
@
Function selector switch
;
Active Vibration Reduction (AVR)
=
Control switch
%

3.2 Intended use

The product described is an electrically powered combihammer. It is designed for drilling in concrete,
masonry, wood and metal. The product can also be used for light to medium-duty chiseling on masonry and
surface finishing work on concrete.
Under certain conditions, the product may also be suitable for stirring / mixing.
▶ Operation is permissible only when connected to a power source providing a voltage and frequency in
compliance with the information given on the type identification plate.

3.3 Description of the device

3.3.1 Active Vibration Reduction
The tool is equipped with an Active Vibration Reduction (AVR) system which reduces vibration noticeably.

3.4 Items supplied

Rotary hammer drill, side handle, depth gauge, operating instructions.
Other system products approved for use with this product can be found at your local Hilti Store or at:
www.hilti.group | USA: www.hilti.com
4 Technical data
Note
For rated voltage, rated current, frequency and/or input power, refer to the country-specific type
identification plate.
If the tool is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the tool. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
Weight in accordance with EPTA procedure 01
Ø hammer drill bits
Ø drill bits for wood
Ø drill bits for metal
Ø mixing paddle with smooth shank (for mixing non-
flammable substances)
16 English
Printed: 08.11.2017 | Doc-Nr: PUB / 5070837 / 000 / 05
1
&
(
)
+
Grip
Supply cord
Forward / reverse switch
Side handle with depth gauge
TE 30 TE 30­AVR
4.0 kg 4.2 kg
5 mm ...28 mm 5 mm ...28 mm
5 mm ...20 mm 5 mm ...20 mm
3 mm ...13 mm 3 mm ...13 mm
•/• •/•