Hilti TE 30 Original Bedienungsanleitung Seite 24

5.1.1 Fitting the side handle
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the product.
CAUTION
Risk of injury! Loss of control over the combihammer.
▶ Check that the side handle is fitted correctly and tightened securely. Check that the clamping
band is engaged in the groove provided on the tool.
▶ Fit the side handle.
5.1.2 Fitting / removing the chuck
CAUTION
Risk of injury. The depth gauge, if fitted but not used, might hinder the operator.
▶ Remove the depth gauge from the product.
Note
The function selector switch should be set to the
▶ Fit / remove the chuck.
5.1.3 Fitting / removing the accessory tool
Note
Use of unsuitable grease may cause damage to the product. Use only the recommended grease
supplied by Hilti.
▶ Fit the accessory tool or, respectively, remove it.
5.1.4 Adjusting the depth gauge
▶ Adjust the depth gauge.
5.2 Types of work
WARNING
Risk of electric shock! Severe injury and burns can result if any attempt is made to operate the tool
without an earth/ground conductor and ground fault circuit interrupter correctly connected.
▶ Irrespective of whether mains power or generator power is used, always make sure that an
earth/ground conductor and ground fault circuit interrupter are present in the power supply and
that these are correctly connected.
▶ Do not use the product unless these safety measures are in place and fully operational.
WARNING
A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if
damaged while working. Disconnect the supply cord plug from the power outlet.
▶ Check the appliance's supply cord at regular intervals and have it replaced by a qualified specialist
if found to be damaged.
Full approval must be obtained from the site engineer or architect prior to beginning the work.
18 English
Printed: 08.11.2017 | Doc-Nr: PUB / 5070837 / 000 / 05
2
3
4
5
"Chiseling" position when changing the chuck.