Hilti TE 30 Original Bedienungsanleitung Seite 25

5.2.1 Drilling without hammer action
TE 30
TE 30-AVR
TE 30-C-AVR
▶ Set the function selector switch to the "Drilling without hammering" position
5.2.2 Drilling without hammer action (1st gear)
TE 30-M-AVR
▶ Set the function selector switch to the "Drilling without hammering" position
5.2.3 Drilling without hammer action (2nd gear)
TE 30-M-AVR
▶ Set the function selector switch to the "Drilling without hammering" position
5.2.4 Drilling with hammer action (hammer drilling)
▶ Set the function selector switch to the "Hammer drilling" position
5.2.5 Chisel positioning
TE 30-C-AVR
TE 30-M-AVR
CAUTION
Risk of injury! Loss of control over the chisel direction.
▶ Do not operate the tool when the selector switch is set to "Chisel positioning". Turn the function
selector switch until it engages in the "Chiseling" position.
Note
The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that flat chisels
and shaped chisels can always be set to the optimum working position.
▶ Set the function selector switch to the "Chisel positioning" position
5.2.6 Chiseling 6
TE 30-C-AVR
TE 30-M-AVR
▶ Set the function selector switch to the "Chiseling" position
5.2.7 Forward / reverse
Note
Operate the forward / reverse selector switch only when the motor has stopped.
▶ Set the forward / reverse selector switch to forward or reverse rotation.
6 Care and maintenance
WARNING
Danger of electric shock! Carrying out care and maintenance while the supply cord is connected to
the power outlet presents a risk of serious injuries including burns.
▶ Always unplug the supply cord before carrying out all care and maintenance tasks.
Printed: 08.11.2017 | Doc-Nr: PUB / 5070837 / 000 / 05
6
7
7
6
8
6
.
.
.
.
.
.
English 19