3 Description
3.1 Overview of the product
Pivotable side handle
@
Chuck (keyless chuck / hex bit holder)
;
Torque and operating mode selector ring
=
Two-speed gear selector switch
%
Forward / reverse selector switch with
&
safety lock
Control switch (with electronic speed
(
control)
3.2 Intended use
SF 6-A22
The product described is a hand-held cordless drill / driver. It is designed for drilling in steel, wood,
plastic, cellular concrete and masonry and for driving and removing screws.
SF 6H-A22
The product described is a hand-held cordless drill / driver. It is designed for drilling in steel, wood and
plastic, for hammer drilling in cellular concrete and masonry, and for driving and removing screws.
▶ Use only Hilti Liion batteries of the B 22 series with this product.
▶ Use only the Hilti battery chargers from the C4/36 series for these batteries.
3.3 Items supplied
Drill / driver, side handle, operating instructions.
You can find other system products approved for your product at your local Hilti Center or online at:
www.hilti.com
3.4 Li-ion battery state of charge display
The Li-ion battery state of charge and malfunctions of the power tool are indicated by the display on the Liion
battery. The Liion battery state of charge is displayed after pressing one of the two battery release buttons.
Status
4 LEDs light.
3 LEDs light.
2 LEDs light.
1 LED lights.
1 LED blinks, the power tool is ready for use.
1 LED blinks, the power tool is not ready for use.
4 LEDs blink, the power tool is not ready for use.
Note
Battery charge state cannot be displayed while the control switch is pressed and for up to 5 seconds
after releasing the control switch.
If the battery charge state LEDs blink, please refer to the information given in the Troubleshooting
section.
3.5 Indication of overloading and overheating
The power tool is equipped with an electronic system to protect against overloading and overheating. The
power tool switches itself off automatically in the event of overloading or overheating. After releasing the
control switch, the power tool may not restart immediately when the switch is pressed again (while the power
tool is cooling down).
16
1
Vibration-absorbing grip
)
Illumination
+
Belt hook (optional)
§
Battery
/
Charge state and fault display (Li-ion
:
battery)
Release button with additional function
∙
(charge state display activation)
Meaning
•
Charge state: 75 % to 100 %
•
Charge state: 50 % to 75 %
•
Charge state: 25 % to 50 %
•
Charge state: 10 % to 25 %
•
Charge state: < 10 %
•
The battery has overheated.
•
The power tool has overheated or is overloaded.