Personal Protective Equipment; Before Use; Preparing For Use - Hilti DD 160 Bedienungsanleitung

5.2.6 Personal protective equipment

en
The user and any other persons in the vicinity must
wear suitable eye protection, a hard hat, ear protec-

6 Before use

CAUTION
The mains voltage must comply with the specification
given on the type identification plate. Ensure that the
power tool is disconnected from the electric supply.
DANGER
When drilling through walls, cover the area behind
the wall, as material or the core may fall out on the
other side of the wall. When drilling through ceilings,
secure (cover) the area below as drilled material or
the core may drop out and fall down.
DANGER
Check that the drill stand is securely fastened to the
work surface.
CAUTION
Do not break the connection to earth by using an
adaptor plug.

6.1 Preparing for use

CAUTION
The machine and the diamond core bit are heavy. There
is a risk of pinching parts of the body. Wear a hard hat,
protective gloves and safety boots.
6.1.1 Mounting the machine on the drill stand
NOTE
The motor section and the carriage form a unit. The ma-
chine can thus be removed from the drill stand together
with the carriage.
1. Remove the end stop screw from the end of the rail.
2. Mount the machine on the drill stand by sliding the
opening in the carriage over the end of the column.
3. Engage the carriage locking system with the channel
and check that the channel is securely fastened.
4. Refit the end stop screw to the end of the rail.
30
All manuals and user guides at all-guides.com
tion, protective gloves and safety footwear while the
machine is in use.
6.1.2 Fitting the hand wheel 4
NOTE
The hand wheel may be fitted on the left-hand or right-
hand side of the carriage.
1.
2.
6.1.3 Fastening the drill stand with an anchor 5 6
WARNING
Use an anchor suitable for the material on which you
are working and observe the anchor manufacturer's
instructions.
NOTE
Hilti M16 metal expansion anchors are usually suitable for
fastening diamond core drilling equipment to uncracked
concrete. Under certain conditions it may be necessary
to use an alternative fastening method. Please contact
Hilti Technical Service if you have any questions about
secure fastening.
1.
2.
3.
4.
5.
6.
7.
Fit the hand wheel onto the shaft on the left-hand or
right-hand side of the carriage.
Secure the hand wheel.
If using the anchor base plate, set an anchor suitable
for the applicable base material at a distance (ideally)
of 267 mm (10 ½ ") from the center of the hole to be
drilled or, if using the combination base plate, at a
distance of 292 mm (11 ½ ") from the hole center.
Screw the clamping spindle into the anchor.
Place the drill stand base plate over the spindle and
align it.
Screw the clamping nut onto the spindle but do not
tighten it.
Level the base plate by turning the four leveling
screws. Take care to ensure that the leveling screws
make firm contact with the underlying surface.
Use a suitable open-end wrench to tighten the
clamping nut on the clamping spindle.
Make sure that the drilling system is secured reliably.