Startup; Check Connections; Turning On The System; Check Output Values - Balluff BTL6-P111-M-A1-S115 series Datenblatt Und Anleitung

BTL6-P111-M_ _ _ _-A1-S115
Micropulse AT Transducer in round profile housing
4 Wiring (cont.)
M12x1
26.5
Fig. 4-2: Connection cable BKS-S...
straight
BKS-S115-00
Ø 6 - Ø 8 Cable Entry
(PG 9 fitting)
M12×1
Ø 20
Fig. 4-3: Connector (female)
Pin numbering for
6
connector, view
of BTL side
7
1
Fig. 4-4: Pin assignments S115,
connector type BTL
5

Startup

5.1

Check connections

Components can be damaged by
improper connections and overvolt-
age. Before you apply power, check
the connections carefully.
5.2

Turning on the system

Note that the system may execute
uncontrolled movements when the
transducer is part of a closed-loop
system whose parameters have not
yet been set. Therefore make sure
that no hazards could result from
these situations.
5.3

Check output values

After replacing a transducer, it is
advisable to verify the values for the
start and end position of the magnet
in manual mode. *
* Transducers are subject to modifi-
cation or manufacturing tolerances.
6

Versions (indicated on part label)

BTL6-P111-M0450-A1-S115
5
4
3
DPI/IP Procedurel
8
Digital output signals:
2
Supply voltage 1 = DC 24 V
Electr. connection: with connector S115
Profile style (round), Ø 30 mm
Nom. length (4 digits), M = metric in mm
Start Stop
5.4

Check functionality

The functionality of the transducer
system and all its associated com-
ponents should be regularly
checked and recorded.
5.5

Fault conditions

When there is evidence that the
transducer system is not operating
properly, it should be taken out of
service and guarded against unau-
thorized use.
5.6

Noise elimination

Any difference in potential - current
flow - through the cable shield
should be avoided. Therefore make
sure the control cabinet and the
system in which the BTL6 is con-
tained are at the same ground po-
tential.
or
Start Stop
english
5 5