Handling And Use; System Requirements; Connecting The Loudspeaker; Switching On/Off And Adjusting The Volume - Silvercrest SLB 1.2 E3 Bedienungsanleitung Und Sicherheitshinweise

Handling and use

This section provides you with important information on handling and
using the device.

System requirements

▯ Computer with sound card and USB connection
or
▯ audio device with audio output (3.5 mm jack plug) and USB
connection (alternatively with external USB power supply).

Connecting the loudspeaker

Ensure that the ON / OFF | VOL control
♦
position.
♦ Plug the 3.5 mm jack plug
socket of your audio device (e.g. notebook, MP3 player).
The audio signals are transmitted via this connection.
NOTE
► Alternatively you can connect an audio cable (not supplied) to
the loudspeaker. One end of the cable must have a 3.5 mm jack
plug to connect to the AUX IN socket
the other end of the cable will depend on the audio output of
the external device.
► As soon as you connect a device to the AUX IN socket
sound signal will be exclusively output via this socket.
♦ Plug the USB plug
(alternatively into the USB socket of an external USB power
supply). The mains adapter should have the following speci-
fications: 5 V
loudspeaker
NOTE
► The loudspeakers
Switching on/off and adjusting the volume
Turn the ON / OFF | VOL control
♦
a click to switch the loudspeakers
Continue turning the ON / OFF | VOL control
♦
to increase the volume.
Turn the ON / OFF | VOL control
♦
the volume.
Turn the ON / OFF | VOL control
♦
hear a click ("OFF" position) to switch off the loudspeakers
SLB 1.2 E3
into the line out or headphone
into a USB socket of your audio device
, min. 500 mA. The power supply for the
is provided via this connection.
do not work without a USB connection!
is in the "OFF"
. The type of plug on
clockwise until you hear
on.
clockwise
anticlockwise to reduce
anticlockwise until you
GB │ IE
, the
.
│
21 ■