Maintenance And Cleaning - Parkside PDAP 75 A1 Originalbetriebsanleitung

♦ Use the pressure reducer on the compressed
air source to set the optimum working pressure .
Note that the maximum working pressure may
not be exceeded . An excessive working pres-
sure does not mean increased output; it merely
increases the air consumption and accelerates
appliance wear . Always comply with the techni-
cal information .
NOTE
► Do not apply the polish too often to the same
surface as the particles it contains could dam-
age the finish .
► Mask any plastic components beforehand as
these could be brightened by the polish .
♦ Switch the compressed air polisher on .
♦ Guide the compressed air polisher parallel onto
the workpiece .
♦ Move the appliance parallel to and evenly over
the surface being polished .
♦ Do not press down on the compressed air
polisher . Pressing down hard does not increase
the working efficiency!
♦ When you are satisfied with the result, release
the trigger to switch off the appliance .
♦ When you have finished working, disconnect
the appliance from the compressed air source .
CAUTION!
► Depending on the size and nature of the
workpiece, suitable safety precautions must
be taken . Use suitable clamps to prevent the
workpiece from slipping .
► In the event of an interruption to the air sup-
ply, release the trigger
PDAP 75 A1
immediately .

Maintenance and cleaning

WARNING! RISK OF INJURY!
Disconnect the appliance from the
compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous
substances that may (due to working pro-
cesses) have accumulated on the appliance .
Avoid all skin contact with these substances .
If the skin comes into contact with hazardous
dusts, this can lead to severe dermatitis . If
dust is produced or swirled up during mainte-
nance, it can be inhaled .
NOTE
To ensure correct functioning and long-term
durability of the compressed air polisher, pay
attention to the following points:
■ Sufficient and continuously intact oil lubrication
is highly important for optimum functioning .
■ Check the speed and vibration levels after each
use .
■ Check the idle speed regularly and after any
maintenance is performed:
use a rev counter and perform the measure-
ment without any clamped tools . At a residual
pressure of 6 .3 bar, the idle speed may not be
exceeded under any circumstances .
■ If the appliance is exhibiting excessive vibration
levels, the cause of the vibrations must be identi-
fied and repaired .
■ Use only the genuine replacement parts recom-
mended by the manufacturer, otherwise you
could put users at risk . In doubt, contact the
Service Centre .
■ Check the polishing disc
age .
■ Clean the appliance with a soft, dry cloth only .
■ Never use sharp or abrasive cleaning agents
under any circumstances .
regularly for dam-
GB │ IE │ 21 ■