Waxing/Polishing Paint Surfaces; Dewaxing/Polishing Paint Surfaces; Cleaning And Maintenance; Cleaning - Parkside PPM 120 A1 Originalbetriebsanleitung

Connect the machine to the power
supply.
1. To switch on, tilt the on/off switch (2) to
position „I", the device turns on.
2. To switch off, tilt the on/off switch (2) to
position „0", the device turns off.
3. Firmly hold the device with both hands
on the handle (1).
Waxing/polishing paint
surfaces
1. Use the towelling cover (5) to apply polish.
2. Apply the wax or polish on a slightly
smaller area than the area you would
like to polish.
3. Work with the polish in a crosswise
movement or circular motions. Exert
only moderate pressure on the surface.
4. Please refer to the information from the
polish manufacturer.
Do not allow the polish to dry out.
There is a risk or surface damage.
Therefore, do not work in direct sun-
light or on a heated surface.
Dewaxing/polishing paint
surfaces
1. Use the synthetic fur cover (4) for
dewaxing purposes.
2. Work in a crosswise movement or
circular motions. Exert only moderate
pressure on the surface.
3. Please refer to the information from the
polish manufacturer.
Cleaning and
maintenance
Pull the mains plug before any ad-
justments, maintenance or repair.
Have any work on the device
that is not described in this
instruction guide performed
by a professional. Only use
original parts. Allow the de-
vice to cool off before any
maintenance or cleaning is
undertaken. There is a risk of
burning!
Always check the device before using it for
obvious deficiencies such as loose, worn
or damaged parts, correct the position-
ing of screws or other parts. Examine the
polishing disc in particular. Exchange the
damaged parts.

Cleaning

Do not use any cleaning agent or
solvent. Chemical substances can
etch the plastic parts of the device.
Never clean the device under run-
ning water.
• Thoroughly clean the device after every
use.
• Clean the ventilation openings and the
surface of the device with a soft brush
or cloth.
• Hand wash to thoroughly clean the
covers after each use. Only use a mild
soap sud.
GB
21