Switching On The Device And Waxing / Polishing The Paintwork; Polishing Or Removing Wax With The Synthetic Polishing Bonnet; Cleaning And Maintenance; Service Centre - Parkside KH8888 Bedienungs- Und Sicherheitshinweise

Note: Too much wax does not necessarily
achieve a better finish and you will have to
spent more time later removing the coating.
3. Spread the wax evenly right up to the edge of
the terry bonnet 6
©
Switching on the device
and waxing / polishing the
paintwork
Note: The paintwork to be polished must be care-
fully cleaned and completely dry. If necessary, use
a paintwork cleaner. Use products that are appro-
priate for the demands on and condition of your
paintwork. Heavily oxidised paintwork will require
the use of a special cleaner. For this use a combined
product (cleaner + wax).
1. Place the waxer / polisher on the surface to be
polished.
Note: To avoid the splattering of wax or polish,
do not switch the appliance on yet. Dab the
appliance a few times at various points on the
area to be buffed. In this way you can ensure
that excess wax / polish is once more distributed
evenly over the terrycloth bonnet and the area
to be buffed.
2. Take both appliance grips
hands and switch the appliance on by pressing
the ON / OFF switch
3. Guide the waxer/polisher evenly over the
paintwork (see Fig. C).
Note: Do not press on the waxer/polisher!
The self-weight of the waxer / polisher alone
applies sufficient pressure for the waxing /
polishing process.
4. Switch the appliance off before you remove it
from the area being buffed. To do this, release
the ON / OFF switch
Any difficult to reach corners or recesses may
have to be completed later by hand. Take the
terry bonnet off the waxer / polisher and
6
use the bonnet for the corners and recesses.
Operation / Cleaning and Maintenance / Service centre
.
firmly in your
3
(see also Fig. B).
5
.
5
©
Polishing or removing wax with
the synthetic polishing bonnet
Note: The wax / polish must be allowed to dry on
sufficiently to produce the best polishing performance.
Otherwise any polish that is still fluid will be smeared
by the polishing bonnet.
Use the synthetic polishing bonnet
polishing or removing the wax.
When working, always follow the instructions
for use of the wax / polish.
©

Cleaning and Maintenance

DANGER OF INJURY! Switch
WARNING!
the device off and pull the plug out of the mains
socket before carrying out any work on the device.
Note: Before cleaning, first remove the battery
pack from the appliance.
CAUTION! Ensure that no fluids can permeate into
the appliance, this could lead to the destruction of
the product.
The appliance is maintenance-free.
Use a slightly moist cloth to clean the housing,
if necessary with a mild detergent.
When cleaning the housing, under no circum-
stances should you use strong detergents,
solvents or abrasives.
Clean the bonnet by washing by hand in
soapy water.
©

Service centre

½
WARNING!
repaired only by qualified specialist
personnel using original manufactur-
er parts only. This will ensure that your
device remains safe to use.
½
WARNING!
lead needs to be replaced, always
have the replacement carried out by
the manufacturer or its service centre.
This will ensure that your device remains safe
to use.
for final
7
Have your device
If the plug or mains
GB 11