General Safety Instructions For Compressed Air Tools - Parkside PDAP 75 A1 Originalbetriebsanleitung

Noise emission values:
Noise measurement determined in accordance
with ISO 15744:
Sound pressure level:
Uncertainty:
Sound power level:
Uncertainty:
Wear ear protection!
Vibration emission value:
Vibration values determined in accordance with
ISO 28927-3 and EN 12096:
a = 0 .25 m/s
2
h
Uncertainty K = 0 .52 m/s
WARNING!
► The noise emission levels specified in these
instructions have been measured in ac-
cordance with the standardised measuring
procedure specified in ISO 15744 and can
be used to make equipment comparisons .
The noise emission values vary in accordance
with the use of the compressed air tool and
may be higher than the values specified in
these instructions in some cases . It is easy to
underestimate the noise emission load if the
compressed air tool is used regularly in a
certain manner .
NOTE
► For an accurate estimate of the noise emission
load during a certain working period, the
times during which the appliance is switched
off or is running but not actually being used
must also be taken into consideration . This
can significantly reduce the noise emission
load over the total working period .
PDAP 75 A1
L = 84 .1 dB(A)
pA
K = 3 dB
pA
L = 95 .1 dB(A)
WA
K = 3 dB
WA
2
General safety instruc-
WARNING!
tions for compressed
air tools
WARNING!
► For multiple hazards: Please ensure that you
have read and understood the safety instruc-
tions before adjusting, operating, repairing,
maintaining or replacement of accessories on
the polisher as well as before working in the
vicinity of the machine . Failure to do this can
result in serious bodily injury .
■ The sander or the polisher should only be ad-
justed, set or used by adequately qualified and
trained operators .
■ This sander or this polisher may not be modi-
fied . Modifications can reduce the effectiveness
of the safety measures and increase the risks for
the operator .
■ The safety instructions should not be lost –
give them to the operator .
■ Never use damaged sanders or polishers .
■ The appliance must be inspected regularly to
ensure that it is labelled with the required rated
values and markings given in this manual . The
user must contact the manufacturer to obtain
replacement labels if necessary .
GB │ IE │ 15 ■