Product Features; Technical Data - Bosch D-tect 150 Professional Originalbetriebsanleitung

Product features

The numbering of the product features shown refers to the il-
lustration of the measuring tool on the graphic page.
(1) Top marking aid
(2) Wheel
(3) Left and right marking aids
(4) Battery compartment cover
(5) Locking mechanism of the battery compartment
cover
(6) Handle
(7) Maintenance flap
(8) Serial number
(9) Sensor area
(10) Right select button
(11) Start button
(12) Left select button
(13) Audio signal button
(14) Setup button
(15) On/off button
(16) Display
(17) LED
(18) Protective bag
Display elements
(a) Audio signal indicator
(b) Battery indicator
(c) Display for sensor range
(d) Area already checked
(e) Measuring scale for permitted drilling depth
(f) Area not yet checked
(g) Outer edges, to be marked left and right via the
marking aid (3)
(h) Operating mode indicator
(i) Grey: Found object is outside the sensor range
(j) Black: Found object is within the sensor range
(k) Centre line, corresponds with the marking aid (1)
(l) Permitted drilling depth indicator
(m) Object material indicator
(n) Live cable indicator

Technical data

Universal detector
Article number
Measuring accuracy to object
A)
centre a
Accuracy of the indicated permit-
A)
ted drilling depth b
Bosch Power Tools
Universal detector
Minimum distance between two
adjacent objects c
Operating temperature
Storage temperature
Radar sensor
– Operating frequency range
– Max. transmission power
Inductive sensor
– Operating frequency range
– Max. magnetic field strength
(at 10 m)
Max. altitude
Max. relative humidity
Pollution degree according
IEC 61010-1
Non-rechargeable batteries
Rechargeable batteries
Operating time, approx.
– Non-rechargeable batteries
(alkaline manganese)
– Rechargeable batteries
(2500 mAh)
Weight according to
EPTA-Procedure 01:2014
Dimensions (length × width ×
height)
Protection rating
A) See image
B) Depends on the size and type of the object, as well as the mater-
ial and state of the base material
C) Only non-conductive deposits occur, whereby occasional tem-
porary conductivity caused by condensation is expected.
The serial number (8) on the type plate is used to clearly identify your
measuring tool.
The accuracy and detection depth of the measuring
u
result may be negatively affected if the base material
D-tect 150
is of poor quality.
3 601 K10 005
For the signal test, which checks whether the measuring tool
B)
±5 mm
is receiving a faulty signal, the conductivity criterion and
level are used that are defined in ETSI TS 103 361 (V1.1.1)
section 9.4.1 for an object depth of d=60 mm.
B)
±5 mm
The following criterion for conductivity is used for the inter-
ference resistance test:
A)
–10 °C to +50 °C
–20 °C to +70 °C
2200–5500 MHz
4 × 1.5 V LR6 (AA)
4 × 1.2 V HR6 (AA)
220 × 97 × 120 mm
IP 54 (dust and splash-
c
b
a
1 609 92A 4G0 | (22.08.2018)
English | 15
D-tect 150
B)
40 mm
0.01 mW
5.9–6.1 kHz
72 dBµA/m
2000 m
90 %
C)
2
5 h
7 h
0.65 kg
proof)