Parts Description; Technical Specifications; Delivery Contents; Safety Notes - ULTIMATE SPEED ULG 15 B4 Bedienungs- Und Sicherheitshinweise

Please note: Cannot be used to jump - start
6 V batteries.
z Parts description
1
Digital display button
2
Battery type button
3
Charge start button
4
"–" pole connection cable (black)
5
"+" pole connection cable (red)
6
Digital display
7 Mains cable
8
Fuse with cover
z Technical specifications
Input voltage:
Return current*:
Nominal output voltage:
Charge current:
Battery type with:
Housing protection type:
* = Return current means the current that the
charger consumes from the battery when
no mains current is connected.
Please note: The maximum charge current
depends closely on the internal resistance of
the connected battery. This internal resistance
is determined by factors such as age, capaci-
ty and the type of the connected battery.
z Delivery contents
Check the scope of delivery and the device
as well as all parts for damage right after
unpacking. Do not take a defective unit or
parts into operation.
1 Charger Ultimate Speed ULG 15 B4
2 Quick contact connection terminals
1 original operating instructions
z Safety notes
KEEP OUT OF THE REACH
OF CHILDREN!
„
„
230 V~ 50 Hz
< 5 mA (no AC
input)
6 V/12 V
2 A, 6 A,
15 A ± 10%
12 V/6 V and
„
8 - 210 Ah
capacity
IP 20
„
Introduction / Safety notes
(1 red, 1 black)
DANGER! Avoid danger to
„
life and danger of injury from
improper use!
CAUTION! Do not operate
„
the device with a damaged
cable, mains cable or mains
plug. Damaged mains cables
pose danger to life from elec-
tric shock.
Have the mains cable only
„
repaired by authorized and
trained specialists if there is
any damage! Contact the ser-
vice point of your country if
you need any repair!
DANGER OF ELEC-
„
TRIC SHOCK! Ensure
that the vehicle is not in opera-
tion if the battery is installed
firmly in the vehicle! Switch off
the ignition and put the vehicle
into the parking position, with
the parking brake engaged
(e.g. car) or the rope attached
(e.g. electric boat)!
GB/IE/NI 21