Wall Mounting; Logging In To The Web Configurator - Auerswald COMfortel WS-500S Betriebsanleitung

Wall Mounting

The COMfortel WS-500S/500M is designed to be mounted on a wall.
Important: Note the location requirements. You must first successfully
plan the DECT radio network.
Note: The COMfortel WS-500M that is only used as a DECT Manager
and Integrator in a large installation can be installed anywhere in range of
the local network.
Fasten the mounting frame on the wall using two
screws:
1. Drill two holes, one above the other, 110
mm apart.
2. Insert dowels and screw the screws in. The
screws must stick out approx. 4 mm.
3. Hang the device on the screws.

Logging in to the Web Configurator

Note for COMfortel WS-500M: Only perform the steps below only for
devices with the device role "DECT Manager and Integrator"
Requirements:
• A PC on which a web browser is installed
• The COMfortel WS-500S/500M and the PC must be in the same network.
Otherwise, check that the firewall and routing settings do not cause
problems.
• You need to know the COMfortel WS-500S/500M's IP address
Note: If the IP address is obtained dynamically from the DHCP server on
the local network, you will find the current IP address in the list of
COMfortel WS-500S/500M - Instructions V01 05/2019
Max. 8 mm
Max. 3 mm
Max. 4 mm
Initial Commissioning
29