Herunterladen Inhalt Inhalt Diese Seite drucken

Nilfisk SW4000 Bedienungshandbuch Seite 79

Vorschau ausblenden Andere Handbücher für SW4000:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

DANGER!
Do not smoke or bring naked flames in the area where the machine is refuelled or where the fuel is stored.
Refuel outdoors or in a well-ventilated area, with the engine off.
Turn off the engine and let it cool down for a few minutes, then remove the fuel tank plug.
Leave at least a space of 4 cm in the filler to allow the fuel to expand.
After refuelling, check that the fuel tank cap is firmly closed.
If any fuel is spilled while refuelling, clean the tank area and allow the vapours to evaporate before starting
the engine.
Do not let fuel come into contact with the skin; do not breathe fuel vapours. Keep out of reach of children.
Do not tilt the engine or the machine too much to avoid fuel spillage.
When moving the machine, the fuel tank must not be full and the fuel valve must be closed.
Do not lay any object on the engine.
Stop the engine before performing any procedure on it. To avoid any incidental start, disconnect the spark
plug cap or disconnect the battery negative terminal.
See also the SAFETY RULES in the Engine Manual, which is to be considered an integral part of this
Manual.
Lead batteries (WET) are installed on this machine, do not tilt the machine more than 30° from its horizontal
position to prevent the highly corrosive acid to leak out of the batteries. When the machine is to be tilted to
perform maintenance procedures, remove the batteries.
(For LPG version). Do not use the machine in case of gas leaks. Disconnect the fuel hose and replace the
LPG tank. If the gas leak persists, disconnect the fuel hose and contact the Nilfisk Service Center.
Carefully read all the instructions before performing any maintenance/repair procedure.
When working near the hydraulic system, always wear protective clothes and safety glasses.
This machine is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the machine by a person responsible for they safety.
Children should be supervised to ensure that they do not play with the machine.
Close attention is necessary when used near children.
Use only as shown in this Manual. Use only Nilfisk recommended accessories.
Check the machine carefully before each use, always check that all the components have been assembled
before use. If the machine is not perfectly assembled it can cause damages to people and properties.
Take all necessary precautions to prevent hair, jewels and loose clothes from being caught by the machine
moving parts.
To avoid any unauthorised use of the machine, remove the ignition key.
Do not leave the machine unattended without being sure that it cannot move independently.
Do not use the machine on slopes with a gradient exceeding the specifications.
Do not tilt the machine more than the angle indicated on the machine itself, in order to prevent instability.
Use only brooms supplied with the machine or those specified in the Instructions for Use Manual. Using
other brooms could reduce safety.
Before using the machine, close all doors and/or covers as shown in the Instructions for Use Manual.
Do not wash the machine with direct or pressurised water jets, or with corrosive substances.
Use the machine only where a proper lighting is provided.
Working lights (optional) have to be used only to enhance visibility on the floor to be cleaned, but they do
not authorize anyone to use the sweeper in dark environments.
While using this machine, take care not to cause damage to people or objects.
Do not bump into shelves or scaffoldings, especially where there is a risk of falling objects.
Do not lean liquid containers on the machine, use the relevant can holder.
03/2013
INSTRUCTIONS FOR USE
1464815000 - SW4000, FLOORTEC R 870
ENGLISH
5

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis

Fehlerbehebung

loading

Diese Anleitung auch für:

Floortec r 870

Inhaltsverzeichnis