Additional Safety Instructions; Safety Precautions; Maintenance And Repair - Parkside PZKS 1500 B2 Originalbetriebsanleitung

Safety information
- This electric tool complies with the
applicable safety rules. Repairs should
only be carried out by qualified persons
using original spare parts, otherwise this
may result in considerable danger to the
user.
ADDITIONAL SAFETY
INSTRUCTIONS

1 Safety precautions

- WARNING! Do not use saw blades
which are damaged or deformed.
- Replace the table insert when worn.
- Only use saw blades recommended
by the manufacturer which conform to
EN 847-1.
- Do not use saw blades made of high
speed steel (HSS steel).
- Wear suitable personal protective
equipment when necessary, this could
include:
- Hearing protection to reduce the risk of
induced hearing loss,
- Eye protection. Sparks generated during
work or splinters, chippings and dust
coming from the device can lead to loss
of eyesight.
- Respiratory protection to reduce the risk
of inhalation of harmful dust,
- Gloves for handling saw blades and
rough materials. Carry saw blades in a
holder whenever practical.
- Always connect the saw to a dust
collecting device.
The emission of dust is influenced, among
other things, by the type of material to
be processed, the significance of local
separation (collection or source), and the
correct setting of the hood/guide plates/
guides.

2 Maintenance and repair

- Pull out the mains plug for any adjustment
or repair tasks.
- The generation of noise is influenced
by various factors, including the
characteristics of saw blades, condition
of saw blade and electric tool. Use saw
blades which were designed for reduced
noise development, insofar as possible.
Maintain the electric tool and tool
attachments regularly and if necessary,
initiate repairs in order to reduce noise.
- Report faults on the electric tool,
protective devices or the tool attachment
to the person responsible for safety as
soon as they are discovered.
3 Safe Operation
- Make sure that a suitable saw blade for
the material to be cut is selected.
- Never use the machine to cut other
materials as specified.
- To transport the machine follow the
procedure of point 9.
When transporting the electric tool, only
use the transport devices. Never use
the protective devices for handling or
transport.
- Operate the machine only if the
protective devices are functional, in good
condition and in the correct position.
- The floor around the machine must be
level, clean and free of loose particles,
such as chips and cutting residues.
- Only use saw blades for which the
maximum permissible speed is not lower
than the maximum spindle speed of the
machine and which are suitable for the
material to be cut.
- Be sure to only use spacers and spindle
rings specified by the manufacturer as
suitable for the intended purpose.
- Attention! Do not replace the laser by
a different type.
GB / IE / NI 93