Introduction; Device Description - Parkside PZKS 1500 B2 Originalbetriebsanleitung

Introduction/Device description

1. Introduction

MANUFACTURER:
Ga-Po-Vertrieb GmbH
Heinrich-Horten-Straße 5
47906 Kempen, Germany
DEAR CUSTOMER,
We hope your new tool brings you much
enjoyment and success.
NOTE:
According to the applicable product liability
laws, the manufacturer of the device does
not assume liability for damages to the
product or damages caused by the product
that occurs due to:
• Improper handling,
• Non-compliance of the operating
instructions,
• Repairs by third parties, not by
authorized service technicians,
• Installation and replacement of non-
original spare parts,
• Application other than specified
• A breakdown of the electrical system that
occurs due to the non-compliance of the
electric regulations and VDE regulations
0100, DIN 57113 / VDE0113.
WE RECOMMEND:
Read through the complete text in the
operating instructions before installing and
commissioning the device. The operating
instructions are intended to help the user to
become familiar with the machine and take
advantage of its application possibilities
in accordance with the recommendations.
The operating instructions contain important
information on how to operate the machine
safely, professionally and economically,
how to avoid danger, costly repairs, reduce
downtimes and how to increase reliability
and service life of the machine.
In addition to the safety regulations in the
operating instructions, you have to meet the
applicable regulations that apply for the
operation of the machine in your country.
Keep the operating instructions package
with the machine at all times and store it
in a plastic cover to protect it from dirt and
moisture. Read the instruction manual each
time before operating the machine and
carefully follow its information. The machine
can only be operated by persons who were
instructed concerning the operation of the
machine and who are informed about the
associated dangers. The minimum age
requirement must be complied with.

2. Device description

(Fig. 1-21)
1. Handle
2. ON/OFF switch
3. Release lever
4. Machine head
5. Movable blade guard
6. Saw blade
7. Clamping device
8. Workpiece support
9. Table insert
10. Miter lock handle
11. Miter detent lever
12. Miter angle pointer
13. Laser
14. Miter angle scale
15. Turntable
16. Fixed saw table
16a.Mounting hole
17. Stop rail
18. Stop for cutting depth limiter
19. Screw for cutting depth limiter
20. Cover plate
21. Sawdust bag
22. Carry handle
23. Bevel angle scale
24. Bevel angle pointer
25. Locking screw for drag guide
26. Drag guide
27. Bevel locking screw
28. Screw for clamping device
GB / IE / NI 89