Cold start lever (fig. 8)
Use this device to start the engine from cold. It will
increase the engine idling speed after starting.
Lever positions:
A) (vertical) = closed
B) fully open.
The lever can be opened and closed gradually to adjust
speed until engine is fully warm (see page 34).
Important
E
Never use the cold start lever when the engine is
warm or leave it open when riding.
620/750
1
20
Right switch (fig. 9.1 and 9.2)
1) Switch, light switch, three positions:
right position
centre position
number plate and instrument panel lights on;
left position
number plate and instrument panel lights on.
2) Switch for ENGINE STOP, two positions:
position
position
cases when you need to stop the engine quickly. After
stopping the engine, return the switch to the
to enable starting.
900
1
switch (2) and leaving the ignition key in the ON
position, may run the battery flat as the lights will remain
on.
3) Button
fig. 8
= light off;
= front and rear parking lights,
= headlight, front and rear parking lights,
(RUN) = run.
(OFF) = stop.
Warning
This switch is mainly intended for use in emergency
Important
Riding with the lights on, stopping the engine using
= engine start.
position