Ducati MONSTER Anleitung- Und Instandhaltungsheft Seite 88

Procedure to disable immobilizer engine block
through throttle twistgrip
1) Turn the key to ON and fully open throttle. Keep it
open. The EOBD warning light turns off after 8 seconds.
2) Release the throttle as soon as the EOBD warning
light turns off.
3) EOBD warning light will come on again, flashing with a
frequency of 0.8 Hz. Count the blinks. Open the throttle
and keep it open when the light will have blinked as
many times as the first figure of the code.
E
It is thus acknowledged the first figure, the EOBD
warning light will come on and will stay on for 4 seconds.
If you do not work the throttle twistgrip, the EOBD
warning light will flash 20 times and it will stay on. Bring
back the key to OFF and repeat the procedure starting
from point (1).
4) Release the throttle twistgrip when EOBD warning
light turns off.
5) Repeat operations described in points (3 and 4) up to
the last figure of the code.
6) Release the throttle twistgrip, if the code is correct,
the EOBD warning light shall flash at a frequency of 1.6
Hz, signalling that engine block has been disabled. The
warning light turns off after 4 seconds.
If the code is NOT correct, the EOBD warning light stays
on and it is then possible to turn the key to OFF and
repeat the procedure, starting from point (1), as many
times as necessary (infinite).
16
Note
Should the throttle twistgrip be released before the
set time, the warning light turns on again. It is then
necessary to bring the key to OFF and restart the
procedure from point (1).
Operation
When the ignition key is turned to OFF, the immobilizer
inhibits engine operation.
When the ignition key is turned back to ON to start the
engine, the following happens:
1) if the CPU recognised the code, the CODE light on the
instrument panel will flash briefly. This means that the
immobilizer system has recognised the key code and
enabled engine ignition. When you press the START
button, the engine will start up.
2) If the CODE light stays on, it means that the code has
not been recognised. When this is the case, turn the
ignition key back to OFF and then to ON again. If the
engine still does not start, try with another black key.
If the other key does not work out either, contact the
DUCATI Service network.
Warning
The keys accommodate electronic components
inside. If dropped or hit, they might damage.
Use only one key during the procedure. Failure to do so
might prevent the system from recognizing the code of
the key in use.