Use; Changing/Inserting The Tool/Collet Chuck; Whet Stone; Fitting Abrasive Belts - Parkside PFBS 160 B2 Originalbetriebsanleitung

Use

Changing/inserting the tool/collet
chuck
♦ Press the spindle lock
♦ Turn the tensioning nut
into place.
♦ Undo the tensioning nut
using the combination spanner
♦ Remove any tool which is inserted.
♦ First push the intended tool through the tension-
ing nut before inserting it into the appropri-
ate collet chuck
♦ Press the spindle lock
♦ Push the collet chuck
and screw the tensioning nut
combination spanner
Using an accessory tool with a mandrel:
♦ Use the screwdriver side of the combination
spanner to undo and tighten the screw on
the mandrel.
♦ Insert the mandrel into the appliance as de-
scribed.
♦ Use the combination spanner
screw on the mandrel.
♦ Insert the desired accessory tool between the
two washers on the screw.
♦ Use the combination spanner
screw on the mandrel.
│ GB │ IE │ NI
■ 10
and hold it down.
until the lock clicks
from the thread
.
for the tool shaft.
and hold it down.
into the thread insert
tight with the
.
to undo the
to tighten the

Whet stone

♦ Do not manually grind any edges with the whet
stone .

Fitting abrasive belts

♦ Push the abrasive belt
mandrel from above. Tighten the screw on
the abrasive belt mandrel
abrasive belt .

Fitting polishing attachments

♦ Screw the polishing attachment
of the mandrel for polishing attachments
Switching on and off/setting speed
range
CAUTION!
■ The rotation direction can be read off the
arrow engraved on the union nut
clockwise symbol).
Switching on/setting the speed range:
♦ Set the ON/OFF switch
♦ Set the infinitely variable speed control
a position between "1" and "MAX".
Switching off:
♦ Move the ON/OFF switch
"O".
onto the abrasive belt
in order to fix the
onto the tip
.
(anti-
to the "I" position.
to
to the position
PFBS 160 B2