To Replace The Backflow Stop; Clean Pump Pedestal; Storage; Waste Disposal And Environmental Protection - FLORABEST FTP 400 D3 Originalbetriebsanleitung

To replace the backflow stop

eplace a defective ac o
"Replacement parts/Accessories").
1. Unscrew the hose adaptor (10)
on the angle adaptor (12) and
remove t e ac o
and seal (11b).
2. Insert the seal (11b) into the
ac o
3. Set t e ac o
tween the angle adaptor (12)
and the
such a manner that the stop is
opened in t e o in direction
and closed a ainst t e o in
direction.

Clean pump pedestal

l a s remove t e mains pl
fore working on the device.
Moving parts create the risk of elec-
troc tion or in r .
Dirt on the bottom of the pump can be
washed down with clear water.
n meas res a ove and e ond t ese
partic larl openin t e e
to e carried o t
case of repairs al a s contact o r service
centre.
stop see
stop 11a
stop 11a .
stop 11
hose adaptor (10) in
ipment are
an electrician. In t e

Storage

• Clean the pump before storage.
Store t e appliance in a dr
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a lon er period it m st e t oro
cleaned after its last use, and before it
is ne t sed.
problems in starting the pump, caused
e- deposits and resid es.
Waste Disposal and En-
vironmental Protection
e environmentall friendl . et rn t e
tool accessories and pac a in to a rec -
clin centre
them.
e- Electric appliances should not be
disposed of in the domestic gar-
bage.
and t e tool in at a rec clin centre.
plastics and metal parts can be separated
and rec cled. s
about this. Defective units returned to us
will be disposed of for free.
G B
t er ise t ere ma
en o ave nis ed
o r Service enter
I E
frost-free
l
e
it
e
2 5