Capturing The Image Into Memory By Using The Freeze Function - Sony 3CCD Bedienungsanleitung

Capturing the Image into Memory by Using the Freeze Function

The unit has frame memory from which a captured image
can be output as a still image to an image processor such as
a computer or a printer.
Frame memory can be controlled in the following three
ways:
• FREEZE button located on the rear panel
• Internal pulse signals
• External pulse signals
You have to change the menu setting to use the freeze
function with these controls.
Note
While the captured image is being output as a still image,
ATW, AUTO IRIS and CCD IRIS cannot be used.
To capture the image into memory using the
FREEZE button
Set "FREEZE" on PAGE 3 menu to "INT.CTRL".
The FREEZE button and SOURCE button on the rear
panel are enabled.
On pressing the FREEZE button: The image is
captured into memory and the captured image is output.
On pressing the SOURCE button: The freeze function
(memory mode) is cleared and the live image is output
from the camera.
To capture to memory using an internal pulse
signal
To capture to memory using internal pulse signals, make the
following menu settings.
1
Set "FREEZE" on PAGE 3 menu to "EXT.CTRL".
2
Set "MODE" on PAGE 3 menu to the desired memory
mode F/F or F/S.
F/F: Whenever an external pulse is input, the image is
captured in the memory, replacing the previously
captured image with the new one and the captured
image is output as a still image. This operation is
repeated cyclically whenever the external pulses are
input.
F/S: When an external pulse is input, the image is
captured to memory replacing the previously
captured image, and the captured image is output as
still image. When the next external pulse is input, the
live image shot with the camera is output. These
operations are repeated cyclically whenever external
pulses are input.
For timing of the pulse signal in F/F mode and F/S mode, see
"Timing of external pulse input to the EXT CTRL connector"
on page 34.
(Continued)
33