Sony 3CCD Bedienungsanleitung Seite 22

Adjusting and Setting with Menus
H.PHASE
When an external reference sync signal for locking the
camera sync generator is input to the EXT CTRL connector
on the rear panel, the camera operates at the frequency of the
reference signal. You can use the H. PHASE function to
perfectly synchronize the camera operation with the
reference signal to the level of the horizontal phase.
You can adjust the level within the range from -99 to +99.
Press the DATA UP and DATA DOWN buttons together to
reset the values to ±00.
Notes
• To perform this adjustment, set "EXT.CTRL (BNC)" to
"GENLOCK". If you set "EXT.CTRL (BNC)" to
"TRIG.IN", no value is displayed.
• When an external reference signal is not input to the EXT
CTRL connector, you cannot change the set value.
SC PHASE
When locking the camera sync generator, use the SC
PHASE function to adjust the subcarrier phase.
Selection Function
SC PHASE Rough Rough adjustment by setting to between 0°
and 180°.
SC PHASE Fine Fine adjustment by adjusting the level within
the range from -99 to +99.
22
Press the DATA UP and DATA DOWN buttons together to
reset the values to ±00.
Notes
• To perform this adjustment, set "EXT.CTRL (BNC)" to
"GENLOCK". If you set "EXT.CTRL (BNC)" to
"TRIG.IN", no value is displayed.
• When an external reference signal is not input to the EXT
CTRL connector, you cannot change the set value.
G SYNC
Adds a sync signal to the G signal in the RGB output.
Selection Function
ON
Select when using a video monitor without a sync
input connector. A sync-added G signal can be output
form the RGB/SYNC connector.
OFF A sync signal is not added to the G output signal.
D-SUB Video
Selects the output signal of
(D-sub 9-pin).
Selection Output signal
VBS VBS signal
YC YC signal
VD VD signal .The VD signal is automatically selected
when "D-SUB Sync" is set to "HD".
RGB/SYNC connector