Blitz Monsun Fast Serie Betriebsanleitung Seite 62

GB
Keep the motor ventilation grids clean. Regularly clean these grids if the work area is particularly dirty.
20. OPERATE THE COMPRESSOR AT THE RATED VOLTAGE
Operate the compressor at the voltage specified on the electric data plate. You could damage or burn-
out the motor and other electric components if the compressor is operated at a higher or lower voltage
than its rated voltage.
21. NEVER USE THE COMPRESSOR IF IT IS FAULTY
If the compressor is noisy or vibrates excessively when running or it seems to be faulty, stop it
immediately and check its efficiency or contact your nearest authorised service centre.
22. DO NOT CLEAN PLASTIC PARTS USING SOLVENTS
Solvents such as gasoline, thinners, gas oil or other compounds that contain
damage the plastic parts. Clean them with a soft cloth and soapy water or other suitable liquids.
23. USE ORGINAL SPARE PARTS ONLY
The use of non-original spare parts involves the annulment of the guarantee and the abnormal running
conditions of the compressor. Original spare parts are available c/o the authorised dealers.
24. DO NOT MODIFY THE COMPRESSOR
Do not modify the compressor. Contact an authorised service centre for all repairs required. An
unauthorised modification may impair the efficiency of the compressor and may also cause serious
accidents for those who do not have the technical skill required to make such modifications.
25. TURN THE COMPRESSOR OFF WHEN IT IS NOT IN USE
When the compressor is not in use turn the main ON/OFF switch OFF (position "0").
26. DO NOT TOUCH HOT PARTS OF THE COMPRESSOR
To avoid scolding do not touch pipes, the motor or any other hot part.
27. DO NOT DIRECT THE JET OF AIR DIRECTLY TOWARDS THE BODY
To avoid all risks never direct the jet of air towards people or animals.
28. DO NOT STOP THE COMPRESSOR BY PULLING ON THE POWER SUPPLY CABLE
Use the "O/I" (ON/OFF) buttons of the control panel to stop the compressor.
29. PNEUMATIC CIRCUIT
Use recommended pneumatic hoses and tools that can withstand the same or a higher pressure than
the maximum running pressure of the compressor.
30. SPARE PARTS
Use only original and identical spare parts to replace worn or damaged ones.
Repairs must be made exclusively by authorised service centres.
31. CORRECT USE OF THE COMPRESSOR
The operator must be perfectly familiar with all the controls and compressor characteristics before
starting to work with the machine.
32. MAINTENANCE JOBS
The use and maintenance jobs of the commercial components fitted on the machine, but not indicated in
this manual, are indicated in the enclosed documents.
33. DO NOT UNSCREW THE CONNECTION WHEN THE TANK IS PRESSURISED
Do not unscrew the connection for any reason whatsoever with the tank pressurised without first
checking if the tank is discharged.
34. DO NOT MODIFY THE TANK
It is prohibited to intentionally drill, weld or deform the compressed air tank.
35. IF THE COMPRESSOR IS USED FOR PAINTING JOBS
a) Do not work in closed rooms or near free flames.
b) Ensure that the room in which you are working is sufficiently ventilated.
c) Wear face and nose mask.
36. DO NOT PUT OBJECTS OR PARTS OF THE BODY IN THE PROTECTION GRIDS
Do not put objects or parts of the body in the protection grids to prevent physical injuries and damage to
the compressor.
KEEP THESE USE AND MAINTENANCE INSTRUCTIONS CAREFULLY AND
GIVE THEM TO PERSONNEL WISHING TO USE THE COMPRESSOR!
WE RESERVE THE RIGHT TO MAKE MODIFICATIONS WHERE NECESSARY
WITHOUT NOTICE
60
hydrocarbons may