Hach Polymetron 8310 Bedienungsanleitung Seite 17

the sensor errors, press the MENU key and select Sensor Diag, [Select
Sensor], Error List. A list of possible errors is shown in
Table 6 Error list for conductivity sensors
Error Description
MEAS TOO The measured value is >
HIGH 2,000,000 µS/cm,
1,000,000 ppm or
20,000 ppt
MEAS TOO The measured value is <
LOW 0 µS/cm, 0 ppm or 0 ppt
ZERO TOO The zero calibration value is
HIGH > 500,000 counts
ZERO TOO The zero calibration value is
LOW < –500,000 counts
TEMP TOO The measured temperature
HIGH is > 130 °C
TEMP TOO The measured temperature
LOW is < –10 °C
ADC The analog to digital
FAILURE conversion failed
Table 6.
Resolution
Make sure that the sensor is
configured for the correct cell
constant.
Make sure that the sensor is
configured for the correct cell
constant.
Make sure that the sensor is held
in air during zero calibration and is
not located near radio frequency or
electromagnetic interference.
Make sure that the cable is
shielded by metal conduit.
Make sure that the sensor is
configured for the correct
temperature element. Refer to
Test the conductivity sensor
on page 16.
Make sure that the sensor module
is fully inserted into the controller
connector. Replace the sensor
module.
Table 6 Error list for conductivity sensors (continued)
Error Description
SENSOR The sensor is missing or
MISSING disconnected
SENS OUT The sensor signal is outside
RANGE of the accepted limits for
the cell constant that is
used (0.01 and 0.05:
100 µS/cm; 0.5:
1000 µS/cm; 1:
2000 µS/cm; 5:
10,000 µS/cm; 10:
200,000 µS/cm)
Warning list for sensors
A warning does not affect the operation of menus, relays and outputs. A
warning icon flashes and a message is shown on the bottom of the
measurement screen. To show the sensor warnings, press the MENU
key and select Sensor Diag, [Select Sensor], Warning List. A list of
possible warnings is shown in Table
Table 7 Warning list for conductivity sensors
Warning Description
ZERO TOO HIGH The zero calibration value
is >300,000 counts
ZERO TOO LOW The zero calibration value
is < –300,000 counts
TEMP TOO HIGH The measured temperature
is > 100 °C
TEMP TOO LOW The measured temperature
is < 0 °C
Resolution
Examine the wiring and
connections for the sensor and for
the module. Make sure that the
terminal block is fully inserted into
the module.
Make sure that the sensor is
configured for the correct cell
constant.
7.
Resolution
Make sure that the sensor is
held in air during zero
calibration and is not located
near radio frequency or
electromagnetic interference.
Make sure that the cable is
shielded by metal conduit.
Make sure that the sensor is
configured for the correct
temperature element.
English 17