Backrest Inclination; Removable Side Plate - Vermeiren Trigo S-line Installationsanleitung

EN
NL

3.2.4 Backrest inclination

The backrest can be adjusted into 5 angle positions:
1. Gently pull the back strap (11) until the backrest is unlocked.
PL
2. Remove the outer screw (12) of the hinging point (13).
3. Move the inner sleeve with second screw to another hole,
CS
according to the desired angle. Lock the position by
retightening the screw (12).
4. Repeat for the second backrest connection.
5. Check the position by moving the backrest until it is locked
into place by the locking pins. Make sure that both locking
pins are secured in the same position.

3.2.5 Removable side plate

Depth of panel (16)
1.
Loosen socket screw (14) and remove socket screw
(15).
2.
Slide side panel (16) forward/backward and retighten
with socket screw (15) in one of the openings of the
support. Tighten socket screw (14) again.
3.
Repeat for the other side panel.
Height of panel (16)
1.
Loosen socket screw (15), remove socket screw (14).
2.
Slide side panel (16) up/down and retighten with socket screw (14) in one of the
openings of the support. Tighten socket screw (15) again.
3.
Repeat for the other side panel.
Height of complete side plate (18)
1.
Remove the side plate from the wheelchair.
2.
Remove the socket screw (17).
3.
Place the socket screw in another hole according to the
desired height (5 positions available).
4.
Firmly tighten the socket screw.
5.
Repeat the adjustments above for the second side plate.
Make sure that both side plates and panels are set to the same
height and depth, and that they are firmly secured.
8
2019-02
Assembly and adjustments
13
12
15
14
16
17
18
17
Trigo
11