Backrest Height - Vermeiren Gemini 2 Gebrauchsanweisung

EN
NL
3.2.2 Backrest inclination
Seat width 32:
Seat width 40:
1. Pull the pin (5).
2. Pull or push the backrest until the desired angle (6 different positions
in steps of 8°). The backrest automatically stops when it reaches the
maximum inclination.
3. Release the pin (5).
4. Check that the backrest is well fixated.
There is an extra hole that prevents that the backrest will be lift back in the
vertical position when the backrest is folded to the seat (for transportation
purposes).

3.2.3 Backrest height

Remove the upholstery to alter the backrest
height.
1. Loosen the two wing nuts (6) on the back of
the backrest.
2. Move the upper part (headrest) (7) of the
backrest upwards or downwards until the
desired backrest height.
3. Retighten the two screws and wing nuts (6)
firmly by hand.
4
1. Loosen the lever (4) on the rear side of the
backrest.
2. Push or pull the backrest tubes in the desired
position (from folded position for easy transport, to
lying down position: 0° - 45°). The backrest
automatically stops when it reaches the maximum
inclination.
3. Retighten the lever (4).
4. Check that the backrest is well fixated.
7
6
8
Gemini 2
2021-06
Using your wheelchair
5