Backlapping - Ransomes Parkway 3 Sicherheits-, Bedienungs- Und Wartungshandbuch

7 OPERATION
blockage. The reel can be rotated by using a spanner on the hexagon drive on the reel non drive end.
4. Check blades for damage and replace or repair if necessary.
5. Start engine and run the cutting units to check for correct operation.

7.11 BACKLAPPING _______________________________________________________

This mower is fitted with the ability to allow the reels to be driven in reverse for backlapping.
• Backlapping is a process which will lightly grind the reel to the bedknife whilst mounted on the mower.
• If significant amounts of metal are to be removed then the cutting unit must be reground on a specialised
grinding machine.
• Before any backlapping is carried out, Ransomes Jacobsen recommends that the backlapping process
must be risk assessed as a workshop process by the manager of the machine.
• Backlapping must only be carried out by trained staff.
• Ransomes Jacobsen recommend that grinding paste is only applied to the reel when it is stationery, the
engine is off and the parking brake applied.
• When applying grinding paste the reel must only be rotated by appropriately sized piece of wood and not
by hand.
• Place reels in the most accessible position for applying the paste.
• After applying the grinding paste the person backlapping must return to the seat, engage the relevant
controls and run the reels in reverse.
• When the desired finish is achieved switch off the mower, clean off any surplus paste, reset the reel to
bedknife and return the controls to the normal mow positions.
Ransomes Jacobsen grinding paste:
Grinding Paste
80 grit grinding paste, 4.5kg tin
120 grit grinding paste, 4.5kg tin
80 grit grinding paste, 9kg tin
120 grit grinding paste, 9kg tin
en-50
Part Number
5002488
5002489
5002490
5002491