Slope Warning Screens - Ransomes Parkway 3 Sicherheits-, Bedienungs- Und Wartungshandbuch

6 CONTROLS
6.2J.7

SLOPE WARNING SCREENS_______________________________________

NOTE
Slope warning screens will only appear when TST is
installed.
During work if the machine is driven onto a slope of 16º
16°
the screen will display this warning which over rides all
other information, and will continue until the machine has
been driven to an area of less than 16º
15
If the slope angle reaches 18º the screen will display
this warning indicating that the cutting unit arms are
locked in the lower position. An audible warning will
18°
also be given, the buzzer will sound four times every 4
seconds and the red LED's will flash four times every 4
seconds. This will continue until the machine has been
driven to an area of less than 15º.
15
If the slope angle reaches 22º the screen will display
this warning indicating that at 22deg the centre and
upper unit will be raised 4"- 6" above the ground to
22°
improve stability and all units will stop rotating. An
audible warning will also be given, the buzzer will sound
four times every 4 seconds and the red LED's will flash
four times every 4 seconds. This will continue until the
machine has been driven to an area of less than 16º.
15
en-34