Operation
WARNING! RISK OF INJURY!
►
Never look into the UV-C lamp
►
Never use the appliance on people or animals! UV radiation can lead to
injuries to eyes and skin.
►
Only operate the appliance when it has been properly assembled.
This is the only way to avoid the dangers of UV radiation.
►
Use this appliance only as described in these operating instructions.
This is the only way to avoid the dangers of UV radiation.
NOTE
►
Use the appliance only if it is completely and correctly assembled. The
dust container
undamaged. If dirt gets into the motor of the unit, it could cause motor
damage.
►
Make sure that the safety switches of the UV-C lamp
of the appliance are not blocked.
►
Test the appliance on a small, unobtrusive spot first.
1) Plug the power plug into a properly installed, easily accessible wall outlet.
2) Place the appliance flat on the surface to be cleaned.
3) Press the On/Off switch
vacuuming.
4) Press the vibration button
shakes up the surface to be cleaned and the swirled up dust is sucked in
through the suction opening
on the UV-C lamp
5) Move the appliance evenly over the surface to be cleaned.
6) After vacuuming, press the On/Off switch
7) Unplug the appliance from the mains socket.
■
28
│
GB │ IE
during use!
and the dust filter
must be inserted correctly and
to turn on the appliance. The appliance starts
to activate the vibration head
. Pressing the vibration button
.
on the underside
. The vibration
also switches
to turn off the appliance.
SMS 300 A1