Replacing The Power Cable; Cleaning, Maintenance, Storage, Transport; And Ordering Spare Parts - Parkside PTK 1700 A1 Bedienungs- Und Sicherheitshinweise

Anleitung_4340686:_ 07.06.2010
to be cut off.
Push the cross stop (13) forward until the
■
workpiece is cut all the way through.
Switch off the saw again. Do not remove the
■
offcut until the blade has stopped rotating.
10.3 Cutting particle boards
To prevent the cutting edges from cracking
when working with particle boards, you should
not set the saw blade (5) more than 5mm
greater than the thickness of the workpiece
(also see Point 9.2).

11. Replacing the power cable

If the power cable for this equipment is
damaged, it must be replaced by the
manufacturer or its after-sales service or
similarly trained personnel to avoid danger.
12. Cleaning, maintenance,
storage, transport and
ordering of spare parts
Always pull out the power plug before starting
any cleaning work.
12.1 Cleaning
Keep all safety devices, air vents and the
■
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it down with compressed air at
low pressure.
We recommend that you clean the
■
equipment immediately after you use it.
Clean the equipment regularly with a damp
■
cloth and some soft soap. Do not use
cleaning agents or solvents; these may be
aggressive to the plastic parts in the
equipment. Ensure that no water can get
into the interior of the equipment.
16:08 Uhr Seite 27
12.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important. The carbon brushes should not be
replaced by anyone but a qualified electrician.
12.3 Servicing
There are no parts inside the equipment which
require additional maintenance.
12.4 Storage
Store the equipment and accessories out of
children's reach in a dark and dry place at
above freezing temperature. The ideal storage
temperature is between 5 and 30 °C. Store the
electric tool in its original packaging.
12.5 Transport
Use only the transport handles (Figure 44)
■
punched into both sides of the housing for
transporting the equipment.
Secure the equipment against slipping; tie it
■
down securely.
Never use the safety devices for handling or
■
transporting purposes.
12.6 Ordering replacement parts
Please provide the following information on all
orders for spare parts:
Model/type of the equipment
■
Article number of the equipment
■
ID number of the equipment
■
For our latest prices and information please go
to www.isc-gmbh.info
GB/
CY
27