Operation - Parkside PTK 1700 A1 Bedienungs- Und Sicherheitshinweise

Anleitung_4340686:_ 07.06.2010
8.5 Adjusting the splitter (Fig. 19-20)
Important. Pull out the power plug.
■
The setting of the saw blade (5) has to be
■
checked each time after changing the saw
blade.
Set the blade (5) to max. cutting depth,
■
move to 0° position and lock in place (see
9.2).
Dismantle the saw blade guard (2) (see
■
8.3).
Take out the table insert (6) (see 8.4).
■
Slacken the fixing screw (30).
■
Push up the splitter (4) until the gap
■
between the saw table (1) and the upper
edge of the splitter (4) equals approx. 10
cm.
The distance between the blade (5) and the
■
splitter (4) should be max. 5 mm. (Fig. 20).
Retighten the fixing screw (30) and mount
■
the table insert (6) (Fig. 8.4).
Remount the blade guard (2) (see 8.3).
■
8.6 Fitting/changing the blade (Fig. 21)
Important. Pull out the power plug and
■
wear protective gloves.
Dismantle the saw blade guard (2) (see
■
8.3).
Remove the table insert (6) by undoing the
■
two countersunk head screws (see 8.4).
Undo the nut with a wrench (size 24) on the
■
nut itself and a second fork wrench (size 10)
on the motor shaft to apply counter-
pressure.
Important. Turn the nut in the direction of
■
rotation of the saw blade.
Take off the outer flange and pull the old
■
saw blade off the inner flange by dropping
the blade at an angle.
Clean the saw blade flange thoroughly with
■
a wire brush before fitting the new saw
blade.
Mount and fasten the new saw blade in
■
reverse order.
Important. Note the running direction.
The cutting angle of the teeth must
point in running direction, i.e. forwards
(see the arrow on the blade guard).
Refit and set the table insert (6) and the saw
■
blade guard (2) (see 8.3, 8.4)
Check to make sure that all safety devices
■
16:08 Uhr Seite 23
are properly mounted and in good working
condition before you begin working with the
saw again.

9. Operation

9.1. ON/OFF switch (Fig. 22/Item 11)
To turn the saw on, press the green button
■
"I" . Wait for the blade to reach its maximum
speed of rotation before commencing with
the cut.
To turn the equipment off again, press the
■
red button "0".
9.2. Cutting depth (Fig. 22).
Turn the hand wheel (8) to set the blade (5)
■
to the required cutting depth.
Turn anti-clockwise:
larger cutting depth
Turn clockwise:
smaller cutting depth
9.3. Setting the angle (Fig. 22)
Undo the fixing handle (9).
■
Turn the handle to set the desired angle on
■
the scale.
Lock the fixing handle again in the required
■
angle position.
9.4 Parallel stop
9.4.1. Stop height (Fig. 23-26)
The stop rail (e) for the parallel stop (7) has
■
two different guide faces (high and low).
For thick material you must use the stop rail
■
(e) as shown in Fig. 25, for thin material
(with a workpiece thickness of less than 25
mm) you must use the stop rail as shown in
Fig. 26.
GB/
CY
23