Before Starting The Equipment - Parkside PTK 1700 A1 Bedienungs- Und Sicherheitshinweise

Anleitung_4340686:_ 07.06.2010
Operating mode S6
Rated operating period/rated idle period (4 min.
on/6 min off)
To prevent the motor from overheating, only
use the bench-type circular saw as follows:
After an operating period of 4 minutes (S 6 =
40%) under the permitted load, you must
interrupt your work for a period of 6 minutes in
which the machine can run idle.
Noise emission values
The noise emission values were measured in
accordance with EN 61029.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
The quoted values are emission values and not
necessarily reliable workplace values. Although
there is a correlation between emission and
immission levels it is impossible to draw any
certain conclusions as to the need for additional
precautions. Factors with a potential influence
on the actual immission level at the workplace
include the duration of impact, the type of room,
and other sources of noise etc., e.g. the number
of machines and other neighboring operations.
Reliable workplace values may also vary from
country to country. With this information the
user should at least be able to make a better
assessment of the dangers and risks involved.
16:08 Uhr Seite 21
Reduce noise generation and vibration to a
minimum!
Use only equipment that is in perfect
■
condition.
Maintain and clean the equipment regularly.
■
Adopt your way of working to the
■
equipment.
Do not overload the equipment.
■
Have the equipment checked if necessary.
■
Switch off the equipment when not in use.
■

7. Before starting the equipment

Idle speed
Before you connect the equipment to the
■
power supply make sure that the data on
101.0 dB(A)
the rating plate are identical to the supply
3 dB
voltage.
111.0 dB(A)
Only ever connect the equipment to a
■
properly installed shock-proof socket which
3 dB
is protected by a 10A fuse as a minimum.
Always pull out the power plug before
■
making adjustments to the equipment.
Unpack the bench-type circular saw and
■
check it for damage which may have
occurred in transit.
Make sure the machine stands securely, i.e.
■
bolt it to a workbench or solid base.
All covers and safety devices have to be
■
properly fitted before the equipment is
switched on.
It must be possible for the blade to run
■
freely.
When working with wood that has been
■
processed before, watch out for foreign
bodies such as nails or screws, etc.
Before you actuate the On/Off switch, make
■
sure that the saw blade is correctly fitted
and that the equipment's moving parts run
smoothly.
GB/
CY
21